Instruction manual

16
After finishing your work and before any type of maintenance is done, it is necessary to
do the following:
1. Close the water valve.
2. Switch the machine to manual mode using the “AUTO/MAN” switch (yellow sig-
nal light off).
3. Switch off the brush motor (1).
4. Turn off the solenoid valve switch (2).
5. Switch off the vacuum motor (3).
6. Lift the squeegee with lever (4). Note: The squeegee blades can be damaged if the
squeegee is not raised during storage or transport.
7. Lift the brush base with lever (5).
8. Take the machine to the location where the recovery tank is to be emptied.
9. Turn the key OFF.
10. Empty the recovery tank by unscrewing the plug on the drain hose.
Note: Wear gloves as protection from contact with dangerous solutions.
11. Empty and clean the hopper (6). Wear gloves to protect your hands from dangerous
chemicals.
12. Clean the squeegee with water.
13. Take off the brushes and clean them with water (for brush disassembly refer to the
section “DISASSEMBLY OF THE ROTATING BRUSHES”).
UPON COMPLETION OF THE WORK