Instruction manual

12
1. STARTING WORK
1. Carry out the operations for the preparation of the machine (see Machine Preparation).
2. Sit on the driver’s seat.
3. Release the parking brake (1).
4. Connect the machine connector to the battery connector (2).
5. Turn the key clockwise to the ON position (3). Both the green signal light (4) and
the digital battery indicator will come on.
6. Switch to automatic operation (5).
7. Press the brush switch (6).
8. Push the brush lever down (7) to lower the brush base assembly. During the
descent, the actuator’s signal light (8) and the brush motor will come on. The light
turns off when the brush base reaches the working position.
9. Press the vacuum motor switch (9).
10. Press the cylindrical brush switch (10).
11. Open the solution water valve (11); rotate it down to the desired flow.
12. Select forward drive (12).
13. Rotate knob (13) to control your speed: Turtle = slow: intermediate position =
normal speed; rabbit = fast.
14. Press the accelerator pedal (14) to move; the squeegee will automatically lower.
During the first few yards of operation, check that the quantity of the cleaning
solution is sufficient and that the squeegee dries the floor surface.
OPERATION