Instruction manual

UPON COMPLETION OF THE WORK

After finishing your work and before any type of maintenance is done, it is necessary

to do the following:

1. Close the water valve through lever (1).

2. Raise the brush base with the pedal.

3. Lift the squeegee with lever (2). Note: The squeegee blades can be damaged if the

squeegee is not raised during storage or transport.

4. Switch off the brush switch (3).

5. Switch off the vacuum motor switch (4).

6. Transport the machine to the location where the recovery tank should be emptied.

7. Empty the recovery tank by removing the drain plug from the drain hose.

WARNING! Use gloves for protection from contact with dangerous

solutions.

8. Take the brush off and clean it with water (for brush disassembly please read the

section “DISASSEMBLY OF THE BRUSH”).