Instruction manual

1
3 2
11
OPERATION
OPERATING
1. Connect the machine connector (1) to the battery connector.
2. Press the brush motor switch (2).
3. Press the vacuum motor switch (3).
4. Adjust the amount of cleaning solution through the lever (4). There should be
enough solution to wet the floor uniformly, but not so much that it gets past the
splash guard. Remember that the correct solution quantity depends on the type of
floor, the dirt and the speed.
5. Release the pedal and lower the brush base.
6. Lower the squeegee using lever (5).
7. The brushes start turning by pressing on the lever (6). During the first few yards of
operation, check that the quantity of the cleaning solution is sufficient and that the
squeegee dries the floor surface.
5
4
6