Specifications

OPERATION
10
Tennant 5400 (04--05)
4. Align brush/pad driver under motor hub and push
driver upward to engage. Be certain that
brushes/pad drivers are secure before operating
machine(Figure8).
FIG. 8
5. To remove brush/pad drivers: raise scrub head,
turn machine of f, remove key and push brush
release knobs downward (Figure 9).
FIG. 9
(For Cylindrical Brush Scrub Head Model)
See REMOVING BRUSHES/PADS.
INSTALLING FaST-- PAK AGENT (OPTION)
Machine must be equipped with the FaST Option.
1. Remove the perforated knock-outs from the
FaST--PAK 365 Floor Cleaning Concentrate
carton. Do not remove the bag from the carton.
Pull out the bag’s hose connector at the bottom of
the bag and remove the orange hose cap from the
connector (Figure 10).
ATTENTION: The FaST--PAK 365 Floor Cleaning
Concentrate is specifically designed for the FaST
system scrubbing application. NEVER use a
substitute, machine damage will result.
FOR SAFETY: When using machine, always follow
the handling instructions on chemical container.
FIG. 10
2. Place the FaST--PAK carton in the carton holder at
the rear of the machine and connect the supply
hose to the FaST--PAK bag (Figure 11).
FIG. 11
NOTE: If any dried concentrate is visible on the
supply hose connector or on the FaST--PAK
connector, soak and clean with warm water.
3. Make sure to connect the supply hose onto the
hose storing plug when not in use (Figure 12).
This will prevent the FaST solution system from
drying out and clogging up the supply hose.
FIG. 12
4. The FaST solution system MUST be primed for
first time use
. To prime system, make sure the
solution tank is empty and operate the machine in
the FaST Scrub Mode for 3 minutes (See
MACHINE OPERA TION). This ste p is only
required for first time FaST system use.
Home
Find...
Go To..