Quick Start Guide

Quick Start Guide:

1. Charge the Battery/Supply Power: Power either by provided

micro-USB cable or by internal Lithium Ion battery. Fully charge the

battery before use for optimal results, approximately 4 hours.

2. Power On/Off: Power ON the Swivel Jack RTX by holding down the

multi-function button (MFB) for 3 seconds or by connecting to USB

power. To power OFF, hold down the multi-function button for 6

seconds or remove from USB power.

3. Pairing:

4. PlaceyourBluetooth®receivingortransmingdeviceinto

pairing mode.

5. TheSwivelJackRTXshouldbepoweredotobegin.

6. Set the Swivel Jack RTX selector switch to TX (Transmit) or RX

(Receive)

7. PresstheSwivelJackRTXmul-funconbuonforroughly5

secondsunlitpowersonandtheLEDlightbeginsrapidly

ashingblue.

8. Wait for up to 30 seconds while the devices connect.

9. Once paired, the LED light will change to either solid blue or

blinking blue if connected in aptX Low Latency. In RX mode, if

your phone or tablet requires a passkey, use: 0000

10. Dual-Link Pairing:

1. Pairyourrstsetofheadphones,followingdireconsabove.

2. Placeyourrstsetofpairedheadphonesasideandputyour

second set of headphones into pairing mode.

3. Start dual link pairing mode on the Swivel Jack RTX by pressing

themul-funconbuonfor3seconds;youwillseearapidly

ashingBluelight.

4. Once your second set of headphones is paired, you will see both

solid blue light. If connected in aptX Low Latency, both LEDs will

blink twice every 5 seconds.