Owner`s manual

3) Attach Coax Rigid Wire antenna. (The unit will not work unless the rigid antenna is properly attached)

(Units with Motor Covers will require a remote antenna kit to mount the antenna outside the motor cover)

4) Verify that the dip switches in the Receiver and Transmitter are set properly.

5) Verify correct wiring. Restore power to Operator.

6) Re-connect Battery in Transmitter and secure cover.

CAUTION

BE SURE THAT ALL COAX FITTINGS AND COAX WIRES DO NOT COME IN CONTACT

WITH ANY PART OF THE METAL CONTROL BOX. THIS WILL RESULT IN A SHORT,

2) Wire to Operator per operator specific wiring diagram. (See Appendix for Wiring Diagrams)

internal components of the door operator.

of obstructions. Make sure a knock out is accessible, and that mounting screws will clear

NOTE: THE OPERATOR REQUIRES AN EXTRA, DEDICATED AUXILIARY CLOSE LIMIT SWITCH.

1) Locate the Receiver on the Operator Control Enclosure, with Antenna pointed down and free

RECEIVER INSTALLATION:

6) Remove cover and disconnect battery until receiver is installed.

is functioning properly.

cover of the unit, and replace the cover. The green LED light should light indicating that the unit

5) Be sure that the battery strap is connected and insert the lithium ion 9 Volt battery into the

CAUTION: DISCONNECT POWER TO OPERATOR

AND WILL DAMAGE THE RECEIVER.