User's Manual

Pairing the Microphones

If the Microphones experience signal loss or drop outs, the microphones should be resynced to the receiver.

In doing so, the receiver will automatically change the operational frequency of each mic.

FOLLOW THE STEPS BELOW TO RESYNC THE MICROPHONES WITH A NEW FREQUENCY CHANNEL.

1. Power the receiver on - Press power button once (1x).

2. Select which Mic channel to be paired:

Note: The ﬂashing receiver LED denotes which Mic channel to be paired.

A. Selecting Mic 1 to pair

i. Press and hold Power/Pair ID button on receiver until the Mic 1 receiver LED is ﬂashing.

B. Selecting Mic 2 to pair

i. Press and hold Power/Pair ID button on receiver until the Mic 2 receiver LED is ﬂashing.

3. When the desired Mic channel LED, Mic 1 or Mic 2, has been selected for pairing, turn on either

handheld microphone to assign the microphone to that Mic channel.

Note: The channel indicator lights on the receiver will then ﬂash and the receiver will power off. This is normal.

4. Power the receiver back on and check that the Mic channel LED is solidly lit on the receiver; this indicates

the microphone was paired successfully.

5. Repeat steps 2-3 for the second microphone.

Notes:

• When pairing, only one microphone can be paired at a time.

• The receiver WILL shut off when it pairs with a microphone, this is normal.

• The receiver will power off if the Power button is continued to be pressed down once the ﬂashing LED has selected Mic.