Quick Start Guide
LUPO
3S
Clear Pairing Record / Reset
The electrical and electronic equipment are
part of a separate collection. Do not throw
electrical or electronic equipment away with
unsorted municipal waste, but ensure that it is
collected separately. Collection systems and locations
(sorting centres, rubbish dumps) are provided for you
by local councils and retailers. By entrusting your
end-of-life product to the proper recycling process, you
are helping to protect the environment and your
health.
QUICK
START
GUIDE
PACKAGE CONTENTS
FIRST USAGE
MIATONE Lupo
BLUETOOTH
Bluetooth
Connected
2S
CONTROLS
2S
x 1
x 1
2S
x 2
x 3
Power On & Off
Track - Play / Pause
Call - Answer
Call - Reject
Active Voice Assistant ( Siri )
TWS Connect / Disconnect
2S
x 1
Next Track
Volume Up
x 1
x 2
x 3
>2S
Press Once
Press Twice
Press Three Times
Hold 2 seconds
TF CARD MODE
TF CARD
TWS CONNECTION
CHARGING
SPECIFICATION
Model: Miatone Lupo
Item Ref: MF02
Bluetooth Version: V5.3
SNR:75dB
Wireless Working Frequency: 2.402-2.480GHZ
Wireless Transmission Distance: up to 33 ft(10M)
Charging Time: approx. 2.5 hours
Charging: DC 5 V / 700 mA
Size: Dia 100 x 46.5 mm
Maximum Operation temperature: 46°C
Care and Maintance
1.
2.
This logo means that no naked flames, such as
a candle can be placed on or near the device.
provided they are correctly supervised, or if the instructions
related to the use of the device have been adequately given
and if the risks involved have been understood. Children
must not play with this device. Children should not clean or
maintain the device without supervision.
6. The electrical socket must remain easily accessible if it
serves as the means of disconnection.
7. Always unplug the device before cleaning it.
8. Clean the device with a soft dry cloth only. Never use
solvents.
9. Attention should be drawn to the environmental aspects of
battery disposal.
10. The battery (batteries or battery pack) shall not be
exposed to excessive heat such as sunshine, fire or the like.
- Before charging, be sure the speakr is at room
temperature, between 46° F (8° C) and 102° F (39° C).
- Use this product only with an agency approved power
supply which meets local regulatory requirements (e.g., UL,
CSA, VDE, CCC) which support 5V / 0.5 A or 1A.
- Use inlcuded charging cable to charge the speaker.
- For the first use, please fully charge the product.
1. Connect the Micro USB end of the included charging cable
to the charging port on your speaker. Then plug the other
end of the USB charging cable into a suitable USB port on
your computer ( or with a standard cell phone charger) to
recharge your speaker’s internal rechargeable battery.
2. You should charge the speaker when hearing low battery
prompt voice. Speaker will power off automatically after
FCC Statement
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications.
However, there is no guarantee that interference will not
occur in a particular installation.If this equipment does
cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference
by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and
receiver.
— Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV
technician for help.
Warning: Changes or modifications to this unit not
expressly approved by the part responsible for compliance
could void the user’s authority to operate the equipment.
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF
exposure requirement.
The device can be used in portable exposure condition
without restriction.
EC Declaration
This product complies with the below listed UK Directives.
Radio Equipment Regulations 2017
The Restriction of the Use of Certain Hazardous
Substances in Electrical and Electronic Equipment
Regulations 2012
The Batteries and Accumulators (Placing on the Market)
Regulations 2008 (as amended) and the Waste Batteries
and Accumulators Regulations 2009 (as amended).
Copyright © 2022 MIATONE Inc. All rights reserved.
Bluetooth is a registered trademark of Bluetooth SIG, Inc.
MIATONE products are registered trademark of MIATONE in the US.
Service contact: support@miatone.com
MIATONE Inc.Oxnard, CA 93022
www.miatone.com
MADE IN CHINA
3 times reminder nofitication.
3.It may take several minutes for your speaker to begin
charging when it's drained. The battery needs to charge
to a minimum voltage before the system can boot up.
4.It’s recommended to power off the units while the
speaker is charging, please don’t play music unitl the unit
is charged for 30 mintues at least, it will help to extend
battery’s life and protect untis well.
3. Use this device in temperate climates only.
4. Use the apparatus in moderate climate only.
5. This device may be used by children aged 8 years or
older and by those with reduced physical, sensory or
mental abilities, or those lacking experience orknowledge,
Important Notice for Charging
RESET
QUICK
START
GUIDE
LUPO
If you have two pieces LUPO, you can use TWS to achieve
wireless stereo combined playing music.
Note: Before TWS pairing, make sure the two LUPO
speakers are not connected over bluetooth.
1. Press for 2 seconds to power on both speakers.
2. After you turn on the device, you should make sure
neither are connected to any bluetooth since both will
automatically reconnect to your previous device. So you
should disconnect existing device first or just turn off
bluetooth on your devices.
3. Press third times on either speaker, a beep will be
heared once TWS is connected.
4.Then make connection with mobile phone.
Notice for TWS Connection
TWS
x 3
TWS Connect
TWS Disconnect
More details operation, please read the back notice.
LUPO is rated by IPX6 waterproof. The speaker can be used
at any place where water exposure is possible.
CAUTIONS:
- Please make sure the charging cover is well sealed before
you use it.
- Do NOT submerge this speaker in any pool of water.
- If the speaker is exposed to salt or chlorinated water,
gently rinse with fresh water following the exposure to
remove residue. Make sure the connector port is fully
dried out before charging.
- Never attempt to charge the speaker while it is wet. Doing
so may cause damage to the speaker.
Waterproof
Electromagnetic Compatibility Regulations 2016.
Electrical Equipment (Safety) Regulations 2016.
2S
x 1
Previous Track
Volume Down
Lit On
Off
Charging
Fully Charged
1S
Switch TF Card / Bluetooth Mode
*Please delete pairing record from the devices and then re-set the speaker.