User's Manual

【SESSION】Default value：S1；
【TARGET】Default value：A；
【TAGFOCUS】Default value：Not checked；As shown in the figure below：：
【Antenna Parameter】： Select the antenna number corresponding to the hardware, and
set the power, power range：21.5dBm MAX；
Note: after the parameters are configured, click
【SET】 to take effect
Reading demonstration
After setting【Reader Setup】， card reading demonstration, click【EPC】, taking the
following parameters as an example：
Click [SET], after setting successfully, click [OK]
again, and then close [reader function setting] interface