User's Manual

4、If you have opened demo before and are still occupying the process, you need
to open the process first and close the demo；
If you still can't connect successfully, you can contact the corresponding salesman or
after-sales technology in time
4．Parameter setting
Reader Setup
Without reading tag data，click【Setup】， and click【Reader Setup】， As shown in the
figure below：
click 【GET】 to get the result. There is a corresponding prompt and the current
function configuration of the device will be displayed
【ANT Inventory Time】： Default value：0ms，
（Parameter Description: this time represents the dwell time of each antenna. When the
time arrives, the next antenna will be switched to start inventory. 0 means that the time
limit is not enabled. If it needs to be enabled, it is recommended to set it to at least
50ms and increase it by 10ms）
【Antenna Inventory Times】： Default value：1，
（Parameter Description: this parameter indicates the inventory times of each antenna.