User's Manual

3. 【Reader IP Add/Port 】 Enter the IP address of the reader, the default is
192.168.0.188, and the port is 4001；
4. 【local IP Add/Port】 Enter local IP address，
【Note: to connect to the network
port, you need to change the local IP address to 192.168.0.xxx, the IP address of
the same network segment as the device, XXX is between 1-255, and cannot be
188】
5. click【Connect】， If the connection is successful, you will be prompted at the bottom
left of the software interface：Connect succeed，The corresponding version number
will be displayed at the bottom right of the interface，The current version number is：
2.0；1.10（The version number will be updated at any time）As shown in the figure
below：
If the display version number is: 1.0.0, the connection fails；
Tips:
Connection failure, please check ：
1、Are the connections normal
2、Whether the power supply is normal and the voltage is stable (12V ~ 24V / 3A)
3、Does demo open repeatedly；