Specifications

Assembly
Step 1) Attaching Rear Unit To Frame
Installing the rear unit to the frame is a simple matter of attaching two pairs of long
and short carriage bolts. Please proceed in the following sequence:
A. Install loosely the two large carriage bolts (A) with their nuts and washers, to the
two holes in the end of the trike frame stay. The heads of the bolts are on the
inside of the frame.
B. Slide the arms of assembled unit between rear frame stays, up to and between
large carriage bolt heads and frame slot. Finger tighten nuts.
C. Align the first most forward holes on unit arms with rear frame slot. Attach the two
shorter carriage bolts (B) and finger tighten. Note that the heads are inside
the frame. (Fig. 1)
D. Make sure that axle flange on unit is to the right side of unit and frame. Also unit
must be installed with support bars up, so that the basket can rest on them.
(Fig. 1)
Torque Specifications
Axle nut front 180 to 240 inch pounds
Brake front cantilever pinch bolt 36 to 48 inch pounds
Brake lever bolt 24 to 36 inch pounds
Brake rear drum cable pinch nut 48 to 72 inch pounds
Crank arm fixed cone min. 300 inch pounds
Crank arm lock nut min. 240 inch pounds
Headset lock nut min. 300 inch pounds
Torque Specifications (cont.)
Pedals 350 inch pounds
Rear unit attaching nuts 300 to 400 inch pounds
Saddle clamp nut 200 to 300 inch pounds
Seat post binder nut 150 to 180 inch pounds
Seat strut (lower) nut 300 to 400 inch pounds
Stem binder nut 170 to 180 inch pounds
Stem expander bolt 175 to 250 inch pounds
A
B
A
B
8
ev3man99.qxd 6/22/99 1:21 PM Page 8