User Manual

15
Restoring Factory Settings
Wall Switch Control
1. Remove the light source
The ceiling light contains three light boards and three protective covers. Each light
board is fixed to the base with two rivets and each protective cover is fixed to the light
board and base with three rivets.
When removing the light source, first uninstall the three rivets from the protective
Replacing the Light Source
Use the wall switch to turn on and off the ceiling light within 5 seconds, you can change
the color temperature from warm yellow light, white light to night light by default. You
can set the favorite light via the app.
Note: Cycling the three light modes twice and pressing the wall switch again will restore the factory
settings of the ceiling light.
Use the wall switch to turn the ceiling light on and off seven times consecutively (turn
off the ceiling light and wait for two seconds, then turn it on and wait for two seconds,
this counts as one time). The ceiling light then starts breathing and automatically restarts
after five seconds, and the factory settings of the ceiling light have been restored.
Note: When using the ceiling light in a new network environment, you need to restore the factory
settings and connect to the network again.
EN