User Manual

12
Warning: Risk of an electric shock. This ceiling light must be grounded.
Warning: Before installing, replacing or inspecting the ceiling light, cut off
the electricity to prevent an electric shock.
6-8mm
Stripped Wire
L
N
3. Connect the stripped wires
The terminal block connector is suitable for wires with a cross-sectional area of
0.75–1.5 mm². Strip about 6–8 mm of the wires, then connect the neutral, ground, and
live wires according to the marks (N, , and L) to the terminal block connector on the
ceiling light. Use a screwdriver to clamp down each line by tightening the screws.
Gently pull each wire to ensure it has been firmly connected.
Note: The wires should run closely along the base in order to avoid shadows on the lampshade. If the
wires are too long, please cut off the excess part.
4. Install the lampshade
Hold both sides of the lampshade and align it with the base, then gently place it onto
the base. Rotate the lampshade clockwise and lock it into the place until the internal
metal part makes a clicking sound.
EN