Owner Manual
Propane Patio Heater Manual 15
• Attach cap nut and leave loose.
• Place reector center plate into middle of reector panels and follow same procedure as above.
• Repeat procedure to complete the assembly of all four sections.
• Fully tighten all of the screws.
STEP 7
Attach Reector Assembly to Studs
• Support Heater.
• Slide 3 large at washers over threaded end of studs.
• Locate Reector Assembly on 3 studs.
• Install large at washers on studs & securely tighten wing nuts but do not over-tighten!
ASSEMBLY
(6) Required Large Flat Washers (3) Required Wing Nuts