Operator`s manual

Kerosene Portable Heaters Manual 13
OPERATION
VENTING
Connect the heater to a ue pipe or to a exhaust duct. To get a proper draft (at least 0,1 mbar) in the ue
pipe, the exhaust gas path must rise. Avoid any elbows and bends in the rst part of the ue pipe for at
least 10 ft. For operation of heater in closed rooms without ue refer to the instructions for installation (page
10, #6).
• If a remote thermostat is used, set it on maximum temperature.
• Turn switch to “ON” position.
• Set the desired temperature on room thermostat.
NEVER LEAVE HEATER UNATTENDED WHILE BURNING OR WHILE CONNECTED TO A FUEL
SOURCE.
CAUTION: WHEN THIS HEATER IS CONNECTED TO A FLUE PIPE, THE FLUE PIPE SHALL
TERMINATE IN A VERTICAL SECTION AT LEAST TWO FEET LONG AND SUFFICIENT DRAFT
SHALL BE CREATED TO ASSURE SAFE AND PROPER OPERATION OF THE HEATER. WHERE
BACK DRAFTS MAY OCCUR, A VERTICAL CAP SHOULD BE USED ON THE EXIT FROM THE
FLUE PIPE. HORIZONTAL RUNS OF THE FLUE PIPE SHOULD HAVE A RISE 1 IN 10 AWAY
FROM THE HEATER.