Operator`s manual

16 Kerosene Portable Heater Manual
MAINTENANCE
PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
Remove upper shell.
Remove fan (See fan blades).
Remove photocell from its mounting bracket
Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near Operation switch.
Disconnect wires from Operation switch and remove photocell.
Disconnect wires from circuit board and remove side cover.
Install new photocell and attach wires to circuit board.
Replace switch wires to operation switch and side cover.
Replace fan and upper shell.
FUEL FILTER
CLEAN TWICE PER HEATING SEASON OR AS NEEDED.
Open rear shell.
Remove lter cover by unscrewing four screws.
Remove fuel lter from lter cover.
Wash fuel lter in clean kerosene.
Replace fuel lter and lter cover.
FUEL FILTER A IN FUEL TANK
Remove fuel cap.
Take out fuel lter from fuel tank.
Wash fuel lter A with clean kerosene.
Replace fuel lter in fuel tank.
Replace fuel cap on fuel tank.
PUMP PRESSURE ADJUSTMENT
1. Remove rear shell.
2. Remove fuel line A from fuel pump by using wrench.
3. Replace pressure gauge at outlet of fuel pump.
4. Adjust pump pressure by turning pressure adjustment screw
5. Replace pressure gauge at outlet of fuel pump.
6. Adjust pump pressure by turning pressure adjustment screw.
7. Turn relief valve clockwise to increase pressure.
8. Turn relief valve counterclockwise to decrease pressure.