Manualshelf

Operator`s manual

ManualsBrandsMi-T-M ManualsDomestic AppliancesKerosene Portable Heaters
11121314151617181920
Kerosene Portable Heater Manual 11
Note: Tools required: medium phillips screw driver, open end or adjustable wrench, long nose pliers.
ASSEMBLING FRAME AND WHEELS
1. Slide axle through wheel support frame. Install wheel bushings, at washers (S) and wheel on axle.
NOTE: When installing wheels, tube valve should face out from support frame.
2. Place at washers (L) and cotter pins on axle ends and bend cotter pins with long nose pliers to secure.
3. Place wheel cap on at washers (L) and put wheel cap in at washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end (rear) of heater is over wheels. Align the holes
on fuel tank ange. Insert screws through handles (front and rear), fuel tank ange, and wheel support frame
as shown in below and attach nut nger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts rmly.
DO NOT OPERATE HEATER WITHOUT SUPPORT FRAME FULLY ASSEMBLED TO TANK.
ASSEMblY