Operator`s manual

16 Kerosene Portable Heater Manual
MAINTENANCE
PHOTOCELL
CLEAN PHOTOCELL ANNUALLY OR AS NEEDED.
Remove upper shell.
Remove fan (See fan blades).
Remove photocell from its mounting bracket
Clean photocell lens with cotton swab.
TO REPLACE: Remove side cover near Operation switch.
Disconnect wires from Operation switch and remove photocell.
Disconnect wires from circuit board and remove side cover.
Install new photocell and attach wires to circuit board.
Replace switch wires to operation switch and side cover.
Replace fan and upper shell.
FUEL FILTER
CLEAN TWICE PER HEATING SEASON OR AS NEEDED.
FUEL FILTER A ON FUEL CAP
Remove fuel cap.
Take out fuel lter with clean kerosene.
Wash fuel lter with clean kerosene.
Replace fuel lter on fuel tank.
Replace fuel cap on fuel tank.
FUEL FILTER B ON FUEL LINE
Remove fuel line A from fuel pump by using wrench.
Take out fuel line from fuel tank by pulling out fuel lter
gasket.
Remove fuel lter assembly from fuel line
Wash fuel lter in clean kerosene.
Reassemble fuel lter in reverse order.
PUMP PRESSURE ADJUSTMENT
1. Remove right side panel. (If not using an accessory fuel pressure
gauge, please skip to #4)
2. Remove air vent screw.
3. Insert accessory fuel pressure gauge at outlet of air vent
screw.
4. Adjust pump pressure by turning pressure adjusting screw.
5. Turn pressure adjusting screw clockwise to increase
pressure.
6. Turn pressure adjusting screw counterclockwise to decrease
pressure.
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Fuel Line A
Fuel Line A
Gasket
Fuel Filter B
Fuel Cap
Fuel Cap
Gasket
Fuel Filter
A
Air Vent Screw
Pressure Adjusting Screw