Operator`s manual
22 Operator’s Manual
Service
5. Blow air through both elements using 42-71 psi
compressed air to remove the particulates. Use the
lowest possible air pressure to remove the dust without
damaging elements.
6. If either element is damaged replace both of them (they
are not sold individually).
7. Clean the inside of the air cleaner cover.
8. Install the air cleaner element into the air cleaner
case.
9. Slide the outer foam element over the air cleaner
element.
10. Install the wing nut and hand tighten. Overtightening the
wing nut will damage the air cleaner assembly.
11. Install the air cleaner cover.
12. Install the wing nut and hand tighten. Overtightening the
wing nut will damage the air cleaner assembly.
PERIODIC MAINTENANCE CHART:
To ensure satisfactory operation over an extended period
of time, an engine requires normal maintenance at regular
intervals. The Periodic Maintenance Chart that follows
shows periodic inspection and maintenance items and
suitable intervals. The bullet mark designates that the cor-
responding item should be performed at that interval.
NotE: Some adjustments require the use of spe-
cial tools or other equipment. An electronic
tachometer will facilitate setting idle and run-
ning speeds.
Daily Every Every Every Before
25hrs. 100 hrs. 200 hrs. Storage
Check fuel •
Check engine oil •
Check for loose or lost nuts and bolts •
Check for leaks •
Check cylinder and head ns for
dust and dirt •
Check battery electrolyte level •
Check fuel lines (replace if necessary) •
Clean air cleaner foam element (**) •
Tighten nuts and bolts (*) •
Change engine oil (*) •
Clean fuel lter •
Replace air cleaner paper element (**) •
Clean dust and dirt from
cylinder and cylinder head ns (**) •
Add fuel stabilizer •
Run unit dry •
* Perform these operations after the rst 5 hours of use, then at the recommended intervals.
** Service more frequently under dusty conditions.
NotE: These items must be performed with the proper tools. See your Mi-T-M Customer Service Repre-
sentative for service, unless you have the proper equipment and mechanical prociency.