User`s manual

Watlow Series C ■ 4 ■ Installation
Installing the Square 1/8 DIN Panel Mount Controller
Figure 4
1. Make the panel cutout using the mounting dimensions above.
2. Remove mounting bracket from the back of the controller.
2. Insert the controller into the panel cutout.
3. While pressing the bezel firmly against the panel, slide the mounting bracket over the back of the controller. Be
sure the levers on the mounting bracket line up with the teeth on the case.
4. Press the bracket up to the back of the panel. The controller should fit tightly in the panel cutout.
Removing the Panel Mount Square 1/8 DIN Controller
1. Remove power from the system.
2. Remove all the wiring connections from the back of the controller.
3. Slide a thin, wide tool (putty knife) under all three mounting tabs, top then bottom, while pushing forward on
the back of the case. Be ready to support the controller as it slides out of the panel cutout.
Screw Terminal Models
68.0 mm
2.68 in
68.0 mm
2.68 in
minimum
19.1 mm
0.75 in
minimum
19.1 mm
0.75 in
72.4 mm
2.85 in
72.4 mm
2.85 in
84.5 mm square
3.33 in
51.7 mm
2.04 in
19.2 mm
0.76 in
Part Number Label
Contact your local Greenlee supplier for the appropriate
punch kit and cutout tool for rapid mounting.
Mounting Bracket
Customer Front Panel
Panel Cutout
Panel Thickness
1.52 to 3.18 mm
(0.060 to 0.125 in)
Terminal Blocks Locations
on Screw Terminal Models
Spade Terminal Model
Spade Terminal Model