User`s manual

Watlow Series C ■ 14 ■ Ordering Information
*Note: Set point must fall within the sensor operating range.
**Note: A (-) is used in the left digit of the operating range to indicate negative temperature values.
On-off controller No user interface
C F - _ _ _ _ - _ _ _ _ - A A A A - _
Set Point Type
F Fixed Set Point
Line Voltage and Output
B
120VÅ (ac), Switched DC Output
C
120VÅ (ac), 8 Amp Relay Output
D
230-240VÅ (ac), Switched DC Output
E
230-240VÅ (ac), 8 Amp Relay Output
F
24VÅ (ac), Switched DC Output
G
24VÅ (ac), 8 Amp Relay Output
Controller Package
1 Panel Mount, 1/8 DIN Square -Spade Terminals
2 DIN Rail Mount -Spade Terminals
3 Open Board, not potted -Spade Terminals
4 Potted Case -Spade Terminals
5 Panel Mount, 1/8 DIN Square -Screw Terminals
6 DIN Rail Mount -Screw Terminals
7 Open Board, not potted -Screw Terminals
Sensor and Scale
H Type J -346 to 1900 Degrees F
J Type J -210 to 1038 Degrees C
K Type K -454 to 2500 Degrees F
L Type K -270 to 1370 Degrees C
M Type T -454 to 750 Degrees F
N Type T -270 to 400 Degrees C
P 100Ω RTD -328 to 1472 Degrees F
R 100Ω RTD -200 to 800 Degrees C
S Type E -328 to 1470 Degrees F
T Type E -200 to 800 Degrees C
Control Mode
H Heat
C Cool
Fixed Set Point Value *
XXXX Control Set Point Value**
Overlay/Custom Options
A Standard
Ordering Information and Model Numbers