User`s manual

Watlow Series C ■ 10 ■ User Interface
Figure 10a — Variable Set Point, Push for Process Interface
Figure 10b — Variable Set Point, Push to Set Interface
F
C
LOAD
PUSH
TO SET
CV
LED Display: Indicates
the set point.
PUSH TO SET Key: Press
and hold key to adjust the
set point temperature. The
new set point is entered 3
seconds after the knob
stops moving. Set point
will not change unless
PUSH TO SET key is
pressed.
LOAD Indicator Light: Lit when
output is energized.
F or C Indicator Light: Lit
to indicate if unit is configured
for degrees Fahrenheit or
degrees Celsius.
Set Point Knob: To increase
set point, turn knob clockwise.
To decrease set point, turn
knob counterclockwise. The
new set point is entered 3
seconds after the knob stops
moving.
CV XXXX XXXX XXXX C
,
Finger Tip Indent: Insert
finger tip into indent for
quick and easy set point
changes.
PROCESS
F
C
LOAD
CV
CV
LED Display: Indicates set point,
until the PROCESS key is pressed.
Process value (actual temperature)
is displayed until the PROCESS key
is released.
PROCESS Key: Press and hold
this key to display process
(actual temperature) value. Set
point is not adjustable until key
is released.
LOAD Indicator Light: Lit when
output is energized.
F or C Indicator Light: Lit
to indicate if unit is configured
for degrees Fahrenheit or
degrees Celsius.
Set Point Knob: To increase
set point, turn knob clockwise.
To decrease set point, turn
knob counterclockwise. The
new set point is entered 3
seconds after the knob stops
moving. Set point will not
change while the PROCESS
key is pressed.
CV XXXX XXXX XXXX B
,
Finger Tip Indent: Insert
finger tip into indent for
quick and easy set point
changes.