Specifications

63D4004 9
OFF ON
Figure 15—The ash lip and
shroud are held in place by a
keyhole slot and bolt system.
Lifting up on the ash lip allows
the bolt head to slip through
the key hole.
Figure 14
Figure 16—As seen from
bottom.
Snapstat
Figure 13
Figure 12
Figure 11
FAN WIRING CONVERSION
FAN WIRING CONVERSION FROM RIGHT TO LEFT
1. Remove ash lip and shroud by lifting straight up. NOTE: The ash
lip and shroud are held in place by a keyhole slot and bolt system.
Lifting up on the ash lip allows the bolt head to slip through the
keyhole.
2. Disconnect ground from side of insert and unplug spade connec-
tors from plug wire.
3. Feed wire through holes in side and front of insert. (Be sure to
leave it connected to the fan.) Push wire through opposite side,
reconnecting ground and plug wires.