Specifications

63D4004 7

Figure 1

Figure 3 Figure 4

Figure 5

Figure 2—Leveling points

UNPACKING AND INSTALLATION INSTRUCTIONS

NOTE: The insert is extremely heavy. Do not attempt to move it without assistance.

Please read all instructions carefully before beginning.

To remove the insert from the pallet you will need a 7/16" wrench or socket.

If you are placing the insert on a raised hearth you might consider moving the complete unit close to the raised hearth

to save some lifting later.

Remove the two brackets on the front of the insert by removing the four bolts (save the two bolts removed from the front

of the stove) shown in Figure 1.

The rear bracket is slipped over the wheel axel and held in place with onebolt shown in Figure 3.

If your hearth is not level there are three leveling points on the insert. One on each of the front corners which are easily

accessed by sliding the corner of the insert just off the edge of the pallet. Figure 2

If the rear of the insert needs to be adjusted you can slide the rear wheel off the pallet and loosen the two bolts (1/2"

wrench) as shown in Figure 4.

The SSI30 is shipped with the power cord for the blower on the right side. If you want to move it to the left side now is

the best time as you can access it under the insert easily by sliding the insert just off the edge of the pallet. See page 9

for instructions on converting fan wire from left to right. Make sure you secure the ground wire (green wire) to the side

of the insert using the star washer showin in Figure 5.

Do not attach the blower until the unit is installed in the ﬁ replace.

•