Operating instructions
75D0004 53
MLDV Series Gas Fireplace
The replace and venting system should be inspected before initial use and at least annually by a
qualied eld service person. Inspect the external vent cap on a regular basis to make sure that no
debris is interfering with the airow. Inspect entire venting system to ensure proper function.
Thoroughly clean the inside of the glass door after using the replace for ten hours. Periodically
clean the glass door as necessary.
When cleaning the glass, remember:
• Allow glass to cool before removal.
• NEVER use abrasive materials.
• Keep children and pets a safe distance away.
• Never operate the replace without the glass door properly secured.
• Never operate the replace if the glass is broken.
• Replace any glass that is chipped, cracked, or broken. Replacement glass door assemblies
MUST be supplied by the replace manufacturer –
• Handle glass door with care to avoid striking or scratching it on hard objects.
To clean glass door, follow “Glass Removal” procedure outlined in the Final Installation section.
Film deposit on the inside of the glass should be cleaned off using a nontoxic, non-corrosive, non-
abrasive, mild-cleaning solution. Simply apply an adequate amount to the glass and wipe off with a
damp cloth. After all maintenance has been completed, re-install glass door.
Leave logs installed in the replace for cleaning. Vacuum surface of the logs with a brush attachment.
If logs must be removed for cleaning, handle carefully by holding gently at each end. Gloves are
recommended to prevent skin irritation from ceramic bers. If skin becomes irritated, wash gently
with soap and water. Vacuum surface of logs with brush attachment or brush logs with a soft bristle
brush (i.e. clean, dry paintbrush). To place logs back in the replace, see “Log Placement” found in
the Final Installation section.
Replace or add rock wool as required following installation instructions in the Final Installation sec-
tion of this manual.