Operating instructions
31
DFX & DBX Series Vent Free Fireplaces
1. Remove optional rebrick panels from packaging. Check
that you have the following:
• 3 rebrick panels
• two () retainer brackets
• two () black screws
If any part or parts are missing, contact dealer where
you bought replace.
. Turn off replace and allow to cool.
3. Remove replace screen, and
logs.
4. Place rear rebrick panel on back wall of rebox. Set
bottom of panel behind the bracket tabs of the grate.
5. Place one of the side rebrick panels in cabinet. Line
up the hole in the retainer clip with the hole inside the
rebox. Using Phillips screwdriver, attach the retainer
bracket to inside of rebox.
6. Repeat step ve for the other rebrick side panel.
FP2520
install back brick
Rear Firebrick
Panel
Bracket Tabs
FP50
Figure 36 -
Install Back Firebrick Panel
FP2521
install side brick
Hole
Retainer
Clip
Side Firebrick
Panel
Screw
FP51
Figure 35 -
Install Side Firebrick Panel
1. Remove black trim from protective packaging. Remove
four (4) black screws and two () 90° angle trim brackets
from owner’s manual packaging.
. Lay trim on oor and match corners of side trims to top
trim.
FP2522
attach trim brackets
FP2523
seaparate trim
FP53
Figure 37 -
Match and Join Corners of
Black Trim with Trim Brackets
FP5