Operating instructions

32 33D4051
OPERATING INSTRUCTIONS
MILLI-VOLT CONTROL LIGHTING INSTRUCTIONS
1. STOP! Read the safety information label.
2. Make sure the manual shutoff valve is fully open.
 3. Thisgaslogsetisequippedwithanignitiondevice(piezo)whichautomaticallylightsthepilot.Ifpiezo
ignitordoesnotlightthepilot,SeeinstructionsforMatch Lighting Instructions, page 32.
4. Turngascontrolknobclockwise totheOFFposition,setthethermostattothelowestsettingandturn
ON/OFF switch to OFF position.
 5. Wait(5)minutestoclearoutanygas.Thensmellforgas,includingneartheoor.Ifyousmellgas,STOP!
Follow"B"inthesafetyinformationlabel.Ifyoudon'tsmellgas,gotonextstep.
 6. FromOFFposition,turnthegascontrolknobcounterclockwise to IGN position. Push in control
knob for 5 seconds.
 7. Withthecontrolknobpushedin,pushinandreleasethepiezoignitorbuttontolightthepilot.
 8. Continuepushingthecontrolknobinforafurther60secondstopreventtheamedetectorfromshuttingoff
thegaswhiletheprobeiswarmingup.Releasethecontrolknob.
 9. Turngascontrolknobcounterclockwise to the ON position.
10. After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch to ON
positionoradjustthermostattodesiredsetting.
11. Ifthegaslogswillnotoperate,followtheinstructionsTo Turn Off Gas To Appliance below and call your
servicetechnicianorgassupplier.
TO TURN OFF GAS TO HEATER
1. Turn control knob clockwise to OFF position to completely shut off the heater.
 2. Ifapplicable:TurnON/OFFswitchtoOFFpositionand/orsetthermostat(ifpresent)tolowestsetting.
3. If applicable: Turn off all electric power to the heater.
Figure 49 - Pilot Figure 50 - Control Knobs Figure 51 - Piezo
WARNING
Wait 30 seconds before readjusting the
heater when the control knob has been
turned down to a lower setting.