Operating instructions

33D4051 27
INSTALLING ROCK WOOL AND CHECKING BURNER FLAME
PLACING ROCK WOOL
24VFSC AND 32VFSC MODELS
Afterinstallinglogs,pullapartdime-sizepiecesofrockwool.Sprinkle
rockwoolevenlyoverburnerports.Washhandsafterinstallingrockwool.
Itchingmayoccur.
WARNING
• Use only rock wool provided with log set.
• Do not add additional rock wool.
• Place rock wool on burner ports only.
• Keep air gap between rear log and burner
CLEAN.
Figure 42 - Correct Appearance of Flames
(24VFSC)
Figure 40 - Rockwool Installation
(24VFSC and 32VFSC)
One-piece
Log
Figure 41 - Correct Appearance of Flames
(24DBXC)
Dime Size
Rock Wool
CHECKING BURNER FLAME
24DBXC MODEL
In normaloperationatfullrateafter15minutes,thefollowing
ameappearancesshouldbeobserved:
The ames inside the one-piece log may be yellow. The
amesshouldextendapproximately2"-4"abovethelog.
See Figure 41.
24VFSC AND 32VFSC MODELS
Innormaloperationatfullrateafter15minutes,thefollowing
ameappearancesshouldbeobserved:
Burner will have a random pattern of yellow ames. See
Figures 42 and 43. Thereshouldbeglowingembersinfront
of burner.
NOTE: The front flames and embers will be an
opaque orange color during the burn off time.
Figure 43 - Correct Appearance of Flames
(32VFSC)