Operating instructions

33D4051 15
GENERAL INSTALLATION INFORMATION
SECURING HEATER TO FLOOR OR HEARTH
Note: Clearance requirements as detailed in “CLEARANCES and HEIGHT REQUIREMENTS” section on
page 17 of this manual, must be met before securing the heater in place.
Topreventmovement,theheatermustbesecuredtotheoororhearth.
1. Open the control access door and remove the screen.
2. Removecartoncontainingthefour-logset.
3. To remove the grate and base assembly, take out two (2) screws as shown in Figure 16.
4. Liftgrateandbaseassemblyoutoftherebox.
5. Securethereboxwithtwoanchoringscrews(
3
/16"x1
1
/4"length)suppliedwiththereplacesystem.See Figure 17.
Note: If the unit is mounted on carpeting, tile or combustible material without the hearth, a metal or wooden
base covering the entire width and depth of the base must be installed.
Figure 16 - Removing Grate
Figure 17 - Securing Heater to Floor or
Hearth
Grate
Screws
3/16" x 1 1/4"
Anchor Screws