Operating instructions

33D4051 13
GENERAL INSTALLATION INFORMATION
45°-angled
Corners
Back of Trim
Assembly
Top Trim Piece
Side Trim Pieces
90°-angled
Shim
90°-angled
Bracket
Outside Corner Slot
Outside
Corner Slot
Bracket
Screws
BLACK TRIM INSTALLATION (32VFSC)
1. Removetrimfromprotectivepackaging.Becarefulnot
toscratchthetrim.Removetwo(2)90°-angledmounting
bracketsandtwo(2)90°-angledshims.
2. Laytrimfacedownontheoor.Lineupthe45°-angled
cornersofthetoptrimwiththe45°-angledcornersofthe
side trims.
Note: Both ends of the top piece of trim are
mitered. See Figure 9.
3. Slideone(1)90°-angledbracket(withattachedscrews)
andone(1)90°-angledshimintheoutsidecornerslot
where the top and side trims meet. See Figure 10.
4. Holdthe corners togethersecurely.Tighten screws on
bracketwithatheadscrewdriver.Makesurethecorners
areushandtherearenospaces.Do not over tighten
screws. See Figure 11.
5. Repeat for other side trim.
6. Slide assembled trim over the top and down the sides of
thereplace.Flushtrimwithfrontofreplaceasshown
in Figure 12.
7. Alignholesinassembledtrimwithholesinsideofre-
place.UsingaPhillipsscrewdriver,attachtrimwithfour
(4)screws provided—two foreach sideof replace.
Tightensnuggly.See Figure 13.
Figure 10 - Securing Corners Together
Figure 11 - Making Sure Corners Are Flush
Assembled Trim
No Spaces
where
Corners Join
Figure 13 - Securing Trim to Heater with Four (4)
Screws Provided
Screws
Screw
Screw
Figure 12 - Sliding Assembled Trim Over the Top
of the Heater
Figure 9 - Lining Up Corners of Trim Kit
Trim Flushed
with Front of
Fireplace
Holes