Operating instructions

12 33D4051
GENERAL INSTALLATION INFORMATION
BLACK TRIM INSTALLATION (24VFSC/24DBXC)
1. Remove black trim from protective packaging. Remove four (4) black screws and 2 (two) 90°-angle trim
brackets from owner’s manual packaging.
2. Lay trim on oor and match corners of side trims to top trim (See Figure 6).
3. Useone90°-angletrimbrackettojointhecornerofonepieceofsidetrimtothecornerofthetoptrimpiece(See Figure
6). A rubber hammer or handle of a claw hammer will help secure the corners.
4. Repeat for other side.
NOTE: If you do not attach the trim at the correct corners, use a hammer and screwdriver to tap on
the one end of the 90°-angle bracket. This will separate the two pieces of trim (See Figure 8).
5. Placeassembledblacktrimonfrontofheater.Usingfour(4)blackscrews,secureblacktrimtosidesofheater(See
Figure 8).
Figure 6 - Matching and Joining Corners of Black
Trim with 90°-angle Trim Brackets
Figure 7 - Removing the 90°-angled Trim Bracket
Figure 8 - Attaching Assembled Black
Trim to Heater
Matched Corners
90°-angle Trim Brackets
Assembled
Black Trim
Black Screw
Holes for Black
Screws
Side Trim
Top Trim
90°-angle Trim Bracket