Operating instructions

38
20306750
Designer Series Direct Vent Gas Fireplace
FIREPLACE INSTALLATION
CAUTION
Each clamp has a quick spring force. When
reinstalling clamps, keep ngers clear.
Figure 58 -
Remove Screen Barrier and Glass Frame
GLASS FRAME REMOVAL
NOTE: You must rst remove the safety barrier before you
remove the glass frame. To remove the barrier, simply lift
up and pull out until the slots on the screen are clear of
their corresponding tabs on the rebox. Then proceed to
remove the glass frame by following the steps below.
1. Remove access panel by lifting up and out.
2. Release two clamps on bottom of replace. Figure 58
3. Tilt glass frame out and lift glass frame up until it clears
three tabs on top of replace.
4. Set glass frame aside.
DANGER
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Un panneau vitré chaud peut
causer des brûlures.
Laissez refroidir le panneau
vitré avant d’y toucher.
Ne laisser jamais les enfants
toucher le panneau vitré.
A barrier designed to reduce the risk of burns from
the hot viewing glass is provided with this
appliance and shall be installed.
Une barrière visant à réduire le risque de brûlure
par le hublot chaude est fournie avec cet
appareil et doit être installé.
DANGER
Safety Barrier
Access Panel
Glass Frame