Operating instructions

69D0023 33
#1 #2 #3 #4 #5 #6 7#
Electronic Valve
GRAY #7
RED #2
RED #2
BLACK #4
GREEN #6
BLUE #1
BLUE
YELLOW
YELLOW
WHITE #3
MAGENTA #5
15’ Wall Switch Wire
BLACK
WHITE
Switch
RS
OFF
ON
Transformer
Secondary
24V
WHITE
WHITE
GREEN
BLACK
BLACK
Primary - 120V
To Junction Box
Pilot Assembly
Spark
Sense
Ignition Module (Synetek)
HI
LO
EV1 EV2
CDV Series Gas Fireplace



Position the wall switch. Do not extend beyond
the 15 feet of wire.

See section entitled HearthMount in the Millivolt
hand held remote instructions supplied with the
remote.
1. Using a flat head screw driver, bend the
“remote” tabs up from the bottom of the
fireplace. Figure45
2. Follow the instructions on remote control to
snap the remote cover plate to the remote
receiver
3. Connect the wire terminal from the remote
receiver. This replaces the 15' wall switch
connection to the switch. Figure44
4. Use the screws that came with the remote
control to mount the remote receiver cover
to the bent up “remote” tabs. Figure45
Figure 44 - Remote Wall Switch Wiring Diagram
Remote Control
Figure 45 - Remote Control Location
“Remote” Tabs

      
    
