Technical data

19
5.8 Add on Modules
5.8.1 Pump module PR 01
The PR 01 pump control serves to control an additional heating circuit pump (pump 2).
Mounting
● Remove the 4 screws on the front of the
pump control.
● Remove the cover.
● Mount the unit in the space provided inside the
boiler casing.
● Refer to the instructions supplied with the unit.
140
60
115
Technical Information
● Supply Voltage – 230V 50Hz
(mains from Strata 3 appliance)
● Maximum contact load – 2A
● Maximum contact rating – 120W
NOTE: The DIP switch of the Strata 3 must be
adjusted so that only one direct heating circuit is
controlled (DIP 1 = OFF).
If the power consumption of pump 2 is more
than 120W, an auxiliary relay is to be installed.
Fig 5.7j
Fig 5.7k
Fig 5.7L
PR01
Control
Module
PR01
Control
Module