Technical data
Table Of Contents
- User Instructions for the Micromat boiler
- Product Description
- Technical Data
- Delivery Consignment / Unpacking the boiler
- Boiler location
- Installation Clearances
- Wall Mounting
- Gas Connection
- Gas Conversion
- System Flow & Return connections
- Condensate Connection
- Flue / Combustion Air connection
- Flue Systems
- Calculating Flue Resistance
- Ventilation requirements single appliances
- Hydraulic System Design
- System type 1
- System type 2
- System type 3
- System type 4
- System type 5
- System type 6
- System type 7
- System type 8
- Water Treatment
- Soldering Flux
- Electrical Connection
- System Type 1
- System Type 2
- System Type 3
- System Type 4
- System Type 5
- System Type 6
- System Type 7
- System Type 8
- Commissioning The Micromat EC
- Installation Codes
- First Firing
- Pop Up Menu
- Setting DHW Temperature
- Servicing
- Screen Display Diagnosis of Faults
Energy Technology
Ltd.
13
The MICROMAT EC is factory fitted for Natural Gas (G20). However the unit can easily be converted to LPG
(G31) by using the kit supplied (part no. 251588) and following the instructions below.
•Remove cover from boiler
•Open the outlet flange joints at the gas combi valve.
•On the outlet side of the gas combi valve add the Ø 5.7mm LPG jets from the conversion kit.
•Re-tighten the flange joint. Do not forget the O-ring.
•Check for Leakage.
•Plug all the air holes (front and back) on the gas/air mixing chamber using the blind grommets supplied.
Enter the gas type to which the MICROMAT EC is converted on the label next to the type label
9.1
gas
conversion