v1.00 - Specifications
mhpro.net 3 axis gyroscope sensor – Iota LPF v1.00 Version 1.0
Connector pinout
Note: The two ground contacts are internally connected. One is normally used for power
and the other as the reference voltage for your project. You must have a common ground
for your project.
Limitation: The gyro outputs must be connected to the input ports of your hardware.
They can not drive LEDs or other electronic components directly.
Centering the Z axis
You only have to momentary press the centering button to set the output à 50% for the Z
axis. If you need a remote centering button, simply use the J2 connector. No need to remove
the S1 button.