Countdown Timer manual_EN_V1.0

mhpro.net V1.0

After making your selection, the module will display "time" one second then displays the

programmed time.

You will then be able to enter the start time of the countdown. After entering the time, the

display will flash rapidly for one second indicating that the time is saved. Then it will show you

"PrId" for Programming Cancel ID (cancellation code). The display will show you the ID already

programmed. You can enter the four digits of the new cancellation code. Again, the display will

flash to confirm the code saving.

Then the display will show « bip 0 » or « bip1 ». This indicates the sound configuration

(1 = sound, 0 = no sound). Make your selection and the display will flash to confirm the

recording.

Finally, the display will show « AL: du » for « Alarm Duration » and will ask you to enter the

alarm duration according to the type of accessory connected. Example: You have connected a

siren as an accessory. You may want to make it sound for 5 minutes. So, enter 00:05:00 or if you

have connected a trigger to drop a banner, you would then activate the solenoid for 5 seconds.

You will enter 00:00:05, and so on.

You are now ready to use the module! You can turn off the module and even disconnect the

batteries, the settings remain saved.