Automatic Wire Cutter manual v1.0

Automatic Wire Cutter manual v1.0 MHPro.net
Setting up the wire
Press the tension lever to insert the wire from the left side between the traction wheel and the bearing
up to over the cutter. Be sure to leave the wire of the cutter protruding. It may be necessary to roll the
wire between your fingers to help get in the way.
Accessories
Depending of the wire diameter, it may be necessary to change the tip and/or the bearing.
Recommended combination
Wire size from 1 mm to 1,5 mm
Green tip with larger bearing (do not use the lock washer)