Automatic Wire Cutter manual v1.0

Automatic Wire Cutter manual v1.0 MHPro.net
“UNITS” menu
To select the unit option, simply rotate the knob slowly until the desired unit is blinking then push the
knob to save and exit. You can also select the back icon if no change. Do not rely on this function to convert
mm to inches and vice versa. Changing units is only a round conversion.
“TRIM” menu
This device has been calibrated for one meter long of 2 mm OD wire. Depending on the precision you
need and the wire diameter, you may want to adjust the accuracy. “TRIM CORRECTION” add/remove
microns of the traction wheel circumference. Increasing this number decreases the length of the wire and
conversely decreasing this number increases the length of the wire. Again, simply rotate the knob until
the desired correction then push the knob to save and exit.
PAUSE (experimental)
During the execution of the task, it is possible to pause the device. Simply press the button to pause and
press again to resume.