Owner`s manual
SAFETY 
IMPORTANT! 
Check for compliance to these safety rules be-
fore each use! 
-Maintain a minimum clearance of 24 inches  
 (61 cm) from sides and back of the grill to  
 any combustible construction. 
-Do not use this appliance under overhead  
 combustible surfaces. 
-Always keep the area around the grill clear  
 from any combustible materials, gasoline, 
 and other flammable gas and liquids. 
-Do not block air to the appliance. 
-Do not block ventilation openings. 
LP Gas Cylinder 
The LP Gas Cylinder which you purchase sep-
arately for use with this grill must meet the fol-
lowing requirements and be equipped with a 
listed Overfilling Protection Device. 
All LP gas cylinders used with this appliance 
must be approximately 12" (30.5 cm) in diame-
ter and approximately 18" (45.7 cm) in height. 
The maximum fuel capacity shall be 20 lbs. 
(9.1 kg) of Propane (43.7 lbs. normal water ca-
pacity). The propane tank must be provided 
with a shut-off valve terminating in a propane 
gas tank valve outlet and be provided with an 
overfilling protection device. 
Please Note: Your Propane Tank accepts a 
Type I, also known a “Quick Connect 
Valve” 
SAFETY 
OPD—Overfilling Protection Device 
As stated, the cylinder you purchase must be 
equipped with an overfilling protection device. 
This type of cylinder can be identified by its tri-
angular shaped tank valve and handle (see 
page 9 for diagram of tank valve and handle). 
Be Certain if you exchange your cylinder, that 
the cylinder you receive in exchange has this 
new OPD safety device. 
The cylinder must be arranged for vapor with-
drawal and remain in the upright position. The 
cylinders must include a collar to protect the 
cylinder valve. 
All LP gas cylinders used with this appliance 
must be marked in accordance with the specifi-
cations for LP gas cylinders of the US Depart- 
ment of Transportation (DOT), or the National 
Standard of Canada CAN/CSA-B339 Cylin-
der, Spheres and Tubes For Transportation of 
Dangerous Goods, and Commission as Appli-
cable. 
Use of LP Cylinder 
Refer to the assembly instructions section 
and the label on the LP cylinder for guid-
ance on proper installation and disconnec-
tion of the LP cylinder. 
SAFETY 
Use of Cylinder Dust Cap 
The cylinder dust cap provided with your tank 
must be used whenever the cylinder tank is 
not connected to the grill gas system. Install 
the dust cap onto the tank valve. Always use 
the tank dust cap and be sure the tank valve 
is closed when storing or transporting the 
tank. 
NOTE: 
-The tank valve must be closed even when  
 using the dust cap. 
-Always transport, store and use the tank in  
 an upright position. 
-DO NOT take or store the tank in a building, 
 garage or enclosed area. 
-Always keep the tank valve closed when the 
 grill is not in use. 
-When removing the dust cap, do so slowly  
 and only after checking to ensure that the  
 tank valve is still closed. 
-Read and follow all safety rules in your in- 
 struction books and on cylinder tank. 
SAFETY 
Filling the LP Cylinder 
Have the tank filled by a reputable propane 
gas dealer. Thee air must be purged from the 
tank by your propane gas dealer before the 
first filling. Have your propane gas dealer 
check the relief valve after filling to ensure 
that it remains free to function, and check for 
leaks. 
SAFETY 
Storage 
DO NOT store the LP cylinder in direct sun-
light. When the grill is to be stored indoors, 
the propane tank MUST b disconnected. The 
3 










