- Modern Home Products Corporation Indoor Fireplace User Manual
29
Vermont Castings EWF36A
20005167
The FK26 fan helps distribute heated air from within
the rebox out into the room. The fan is controlled by a
snapstat that turns power on and off as the rebox tem-
perature rises above and falls below a preset tempera-
ture. A rheostat provides for variable fan speeds.
115 Volt / 60Hz / .75 Amps
The fan itself does not require regular maintenance,
however, periodic cleaning of the fan and the surround-
ing area is required.
1. Place fan assembly at the back of the unit between
hearth supports. Attach using velcro strips provided.
(Fig. 33)
2. Install thermal sensor (snapstat) on bottom of rebox
by sliding between bracket and rebox.
3. Place electronic fan speed control box (rheostat) to
side bracket. Fasten fan speed control box with #10
- 24 hex nuts.
4. If the EB-1 receptacle box (Pt. #ZA1200) was cor-
rectly connected when the unit was installed, the
fan lead can be directly plugged into the EB-1 plug
socket.
FP1323
FK26 fan install
2/27/03 djt
Fan
Heat Sensor
(Snapstat)
Electrical
Box
Fan Speed Switch
(Rheostat)
FP1323
FK26 fan placement.
A cast face trim kit and a cast louvre kit are available to
enhance the look of your EWF36A replace. Installation
instructions are included with the kit.
EWF36ACFTK Cast Face Trim Kit
EWF36ACLK Cast Louvre Kit
An optional spark screen, EWF36S, is available to allow
the replace to be operated with the doors fully open.