User’s Manual 2.4G RF Modular RF-24G Version v1.
Description: RF-2.4G Modular PCB Assembly is an i/o board used in the family of REMOTE POWER SWITCH PRODUCTS,The board has RF+MCU POWER circuit OSC circuit RESET circuit and wireless module. CIRCUIT DESCRIPTION: Referring to the block diagram there are four main sections of circuit: 1, el2401 IC MCU CIRCUIT 2, CLOCK CIRCUIT 3, ANTENNA CIRCUIT 4, RESET CIRCUIT Communication with the RF-2.4G Modular is accomplished through two side PCB PADS, the 2.4G ISM RF circuitry is contained on the module.
FMA Main PCB Interface Header AII control and power signals come from a connection to a mother board through an 16-pin, 2.54mm dual row female header. The pinout for the header is in the table below: Antenna An F-type PCB antenna is located on the PCB to support the 2.4GHz signal from the RF-2.4G modular,and the maximum antenna gain is 0dBi.
Board Dimensions IC Statement: This device complies with Canada Industry licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not cause interference; and (2) this device must accept any interference. Including interference that may cause undesired operation of the device.
Radiation Exposure Statement: This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. Déclarationd'exposition aux radiations: Cetéquipementestconforme aux limitesd'exposition aux rayonnements IC établies pour un environnement non contrôlé. IMPORTANT NOTE: This module is intended for OEM integrator. The OEM integrator is still responsible for the ICcompliance requirement of the end product, which integrates this module.
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Warning: Changes or modifications to this unit not expressly approved by the part responsible for compliance could void the user’s authority to operate the equipment. Note:The module is limited to OEM installation ONLY;The OEM integrator is responsible for ensuring that the end-user has no manual instructions to remove or install module. This product is mounted inside of the end product only by professional installers OEM.
