Computer Hardware User Manual

ENERGIZE YOUR ENTERPRISE
Network Management Card
– User Manual 34003991EN/DA Page 86/120
7.2.3 Configuration of the JBUS/MODBUS communication parameters
◗ Use the cord supplied with the card.
◗ Connect the card to a computer equipped with a Hyper terminal type emulator. The serial link must be set at 9600
baud, 8 bits, no parity, 1 stop bit, and without flow control.
◗ Check that UPS power is on.
◗ Enter the MGEUPS or mgeups password (not modifiable).
Connect the RS232 link
to a terminal
(Microsoft Hyper
terminal)