Installation manual

34003905EN/AE
The Network Management Card is recommended for central UPSs
protecting entire networks or for UPS units backing up critical loads.
With the card installed, the UPS has its own IP address and uses the
local computer capabilities to:
◗ Supply web pages (http or https (SSL)) with information on status
conditions and measurements/settings/alarms,
◗ Integrate an SNMP-based NMS such as HP OpenView, IBM Tivoli
Netview and Computer Associates Unicenter,
◗ Communicate with the protection software installed on the protected
servers (Network Shutdown Module or Netwatch),
◗ Send e-mail and SMS messages,
◗ Control the ON/OFF function of the UPS and the outlets,
◗ Monitor the Environment Sensor (optional, cat. no. 66846).
◗ One Network Management Card,
◗ One serial cable for configuration (34003918),
◗ One installation manual (34003905).
Note.
◗ If the technical level of the UPS is lower than that indicated in the
compatibility list, contact EATON.
ETHERNET port
Service port (Settings/Sensor)
INTRODUCTION
UNPACKING AND CHECKS
CHECK ON UPS VERSION
Important. Before installing the card, check that the UPS
technical level (NT) is at least equal to that indicated in
the compatibility list (For latest information, check the
website according to your product :
download.mgeops.com for MGE Office Protection
Systems products, www.powerware.com for Powerware
products) .
OVERVIEW
INDICATIONS
LED Colour Status Description
ACT Green ◗ OFF
◗ ON
◗ Flashing
◗ Card not connected to network
◗ Card connected to network, but no
activity
◗ Port is sending/receiving
100M Orange
◗ OFF
◗ ON
◗ Port operating at 10 Mbits/s
◗ Port operating at 100 Mbits/s
LED Colour Status Description
UPS
Data
Green ◗ OFF
◗ ON
◗ Flashing
◗ Card starting
◗ Communicating with UPS
◗ Normal operation
Communication with UPS is
operational
RS232 Orange
◗ OFF
◗ ON
◗ Flashing
◗ Configuration menu activated
◗ Normal operation
Configuration menu not activated
◗ Communication with Environment
Sensor (option)
00:20:85:FD:1C:07
ETHERNET 10/100BT port
Service port (Settings/Sensor)
Orange LED: RS232 activity
Green LED: communication
with the UPS
Orange LED: 10/100M
Green LED: connection +
activity
MAC address