www.eaton.com Network Management Card Minislot Installation manual 34003905EN/AE www.eaton.
INTRODUCTION OVERVIEW The Network Management Card is recommended for central UPSs protecting entire networks or for UPS units backing up critical loads.
INSTALLATION The Network Management Card can be hot-plugged on all UPSs compatible with the card. It is not necessary to shutdown the UPS, disconnect the load or restart the UPS. ◗ Remove the plastic cover of the Minislot. ◗ Note the MAC address of the card before inserting it. ◗ Insert and secure the card with the screws. ◗ Connect the ETHERNET cable. ◗ Check the ETHERNET port indications. ◗ Wait until the UPS Data LED flashes regularly (approx.
USER MANUAL This manual provides all the information required to install and configure the Network Management Card. For more information on the supervision, control and configuration functions offered by the Network Management Card, see the user manual available at download.mgeops.com or in the Products/Power Management section at www.powerware.com. SENSOR CONNECTION (option) The Environment sensor is a Network Management Card option. It is available from EATON (cat. no 66846).
