User manual

THE UNINTERRUPTIBLE POWER PROVIDER
Network Management Card – User Manual 34003991EN/GA - 56 -
Battery switch (QF1) open Battery switch (QF1) closed
Manual Bypass switch (Q3BP) closed Manual Bypass switch (Q3BP) open
Load not protected - On Manual Bypass
Inverter limitation Inverter end of limitation
Inverter fuses blown Input fuses OK
Inverter fault Inverter OK
Inverter overload Inverter load OK
Inverter overtemperature Inverter temperature OK
Inverter thermal overload Inverter load OK
Output switch (Q5N) open Output switch (Q5N) closed
Load short circuit Load OK
Normal AC NOK Normal AC OK
Low battery Battery OK
UPS communication failed UPS communication restored
UPS data base not available UPS data base OK
UPS on battery UPS on normal AC
Load not powered Load powered
UPS internal fault UPS OK
Battery fault Battery OK
UPS overload UPS returns to normal load
UPS overtemperature UPS temperature OK
Imminent UPS shutoff UPS OK
< Sensor Name> : Temperature is above high threshold
<xx> (°C) or (°F)
<Sensor Name> : Temperature is in normal range
< Sensor Name> : Humidity is above high threshold <xx> (%) <Sensor Name> : Temperature is in normal range
< Sensor Name> : Temperature is below low threshold <xx>
°C or (°F)
<Sensor Name> : Temperature is in normal range
< Sensor Name> : Humidity is below high threshold <xx> (%) <Sensor Name> : Temperature is in normal range
<Sensor name>: <Input #1 label> <when closed label>
<Sensor name>: <Input #1 label> <when open label>
<Sensor name>: <Input #2 label> <when closed label>
<Sensor name>: <Input #2 label> <when open label>>
7.1.3 Table of system alarms
Network Management Card startup
Send test mail SUCCESS
Send test mail ERROR
Send mail to <recipient> ERROR
<Sensor name> Communication failure
<Sensor name> Communication restored
Firmware upgraded