Installation manual

34003905EN/AA
The Network Management Card (66102) is recommended for central
UPSs protecting entire networks or for UPS units backing up critical
loads.
With the card installed, the UPS has its own IP address and uses the
local computer capabilities to:
◗ supply web pages (http or https (SSL)) with information on status
conditions and measurements/settings/alarms,
◗ integrate an SNMP-based NMS such as HP OpenView, IBM Tivoli
Netview and Computer Associates Unicenter,
◗ communicate with shutdown modules installed on the protected
servers (Network Shutdown Module),
◗ send e-mail and SMS messages,
◗ control the ON/OFF function of the UPS and the outlets,
◗ monitor the Environment Sensor (optional, cat. no. 66846).
◗ One Network Management Card (66102),
◗ One serial cable for configuration (34003918),
◗ One installation manual (34003905).
Note.
◗ If the technical level of the UPS is lower than that indicated in the
table, contact MGE UPS SYSTEMS.
◗ The Network Management Card (66102) is not compatible with the
Pulsar EX 7/10/15/20/30 and Pulsar ESV+ 8/11/14/22 ranges.
ETHERNET port
Service port (Settings/Sensor)
INTRODUCTION
UNPACKING AND CHECKS
CHECK ON UPS VERSION
Important. Before installing the card, check that the
UPS technical level (NT) is at least equal to that
indicated in the table below.
UPS Type Technical level (NT)
Pulsar Extreme C 700/1000/1500 B2
Pulsar Extreme C 2200/3200 02
Pulsar Evolution 500/800/1100 06
Pulsar Evolution 1500 05
Pulsar Evolution 2200/3000 05
Pulsar EX RT (US) 700/1000/1500 03
Pulsar EX 2200 RT (US) 2200 09
Pulsar EX 3200 RT (US) 3200 09
66102
Settings/Sensor
ETHERNET
100M
10M
U
PS
d
ata R
S232
Installation manual
MGE
UPS SYSTEMS
T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
MGE UPS SYSTEMS
www.mgeups.com
Network
Management
Card Minislot
2006 Edition
(66102)
6
61
02
Settings/Sensor
ETHERNET
100M 10M
UPS data RS232
On = Link
Blink = Act
OVERVIEW
INDICATIONS
LED Colour Status Description
ACT Green ◗ OFF
◗ ON
◗ Flashing
◗ Card not connected to network
◗ Card connected to network, but no
activity
◗ Port is sending/receiving
100M Orange
◗ OFF
◗ ON
◗ Port operating at 10 Mbits/s
◗ Port operating at 100 Mbits/s
LED Colour Status Description
UPS
Data
Green ◗ OFF
◗ ON
◗ Flashing
◗ Card starting
◗ Communicating with UPS
◗ Normal operation
Communication with UPS is
operational
RS232 Orange
◗ OFF
◗ ON
◗ Flashing
◗ Configuration menu activated
◗ Normal operation
Configuration menu not activated
◗ Communication with Environment
Sensor (option)
66102
Settings/Sensor
ETHERNET
100M 10M
UPS data RS232
000623001C07
ETHERNET 10/100BT port
Service port (Settings/Sensor)
Orange LED: RS232 activity
Green LED: communication
with the UPS
Catalogue number
Orange LED: 10/100M
Green LED: connection +
activity
MAC address