Owner`s manual

2.2.0 Mechanical Mounting
The equipment can be either mounted on a floor, or rack-mounted in a 19”, 23”, or 25” rack. Optional
mounting bracket kits can be ordered for rack mounting in a 19” or 23” rack. Ordering information is as
follows:
All receivers and inverter power modules are shipped separately from the factory. Receivers will be shipped
on a pallet. These receivers can be secured to a floor or to some other permanent base using one-half inch
bolts through the four holes in the base supports. The inverter modules will be shipped based on customer’s
discretion on power configuration or the size of the receiver they are using. Modules will be shipped separately
from exterior chassis. Refer to Figure 2-2 on page 2—4.
3.5 to 21 kVA N+1 Inverter
Installation & Operationpage 2 —2